- Metal Insulation Stick Pins
- 【Brief】：
Type: metal insulation stick pins
material: stainless steel
base thickness: 1.0mm
base size: 50mmx50mm
pin thickness:3.0mm
pin length:63.5mm
- 【Series】：Insulation hangers
- Description
Metal Insulation Stick Pins
Detail Specification Of Self Adhesive Insulation Stick Pins:
Material:Galvanized steel in common, also could be stainless steel and aluminum
Tape color: red, white, blue, etc
base type: flat washer type and stamp pattern washer type
base thickness with stick tape:1mm
Specification Self Adhesive Insulation stick Pins
Pin diameter Base size Pin length in common self locking Clips Size 2mm,
2.2mm,
2.4mm,
2.7mm,
3.0mm
20mmx20mm
40mmx40mm
50mmx50mm
65mmx65mm
1'' round type/ square type 1-2" 15mm 2" 20mm 2-1/2" 25mm 3" 28mm 4" 30mm 5" 38mm The Self Stick Adhesive Insulation Anchors also could be produced as request via from material, pin dia and length.
Tecnical data of self adhesive insulation hangers
Adhesive
base:
polyethylene foam
coating:
acrylate adhesive on both sides
liner:
siliconized paper
thickness:
1mm
Power (FINAT-TM 1)
1 minute
>18 N/25 mm
20 minutes
tear
24 hours
tear
Shear strength (FINAT-TM 8)
23 °C
>150 hours
70 °C
1 hour
Advantages of the Self Adhesive Insulation stick Pins
1. Environmentally-friendly
2. Light, dust free, fire retardant and easy to install, because of annealing surfacetreatment for pins.
3. Heat reflection, heat insulation, sound insulation, counter radiation, counter vibration and shielding
4. During Summer: moisture barrier, sun protection, waterproof, energy saving consumed by cool air conditioning
5. During Winter: heat protection, remarkable energy saving consumed by warm air conditioning
6. copper plated or galvanized surface treatment , rustproof
Application of insulation stick pins
The user is responsible for determining the suitability of the application.
- Hangers must be applied to a clean, dry, non-porous surface that is free of all oil, films, dust, rust, etc.
- Self-adhering hangers are not recommended for concrete or painted surfaces.
- It is important that they not be used where operating temperatures can exceed 150° F at the point of adhesion.
- Hangers should not be used on ceilings or roofs of metal buildings or any surface the reverse side of which may be exposed to
- heat concentration from sunlight, etc.
